90S100U - OREGON CHAIN SAW - 100' REEL 90PX100U chain is part of a Micro-Liteâ„¢ narrow-kerf cutting system that requires less power from the saw to cut than standard cutting systems. 90PX100U is a low-kickback chain Low-vibration chamfer-chisel cutters have an angular shape with twin cutting corners for excellent performance and edge-holding durability Narrow .043" gauge helps reduce the weight of the bar-chain combination approximately 15% Always install 90PX100U chains on a .043" gauge Micro-Liteâ„¢ bar (MLE part numbers) to obtain all the advantages of the Micro-Liteâ„¢ system. 90PX100U chain does not fit .050" gauge bars intended for 91-series chains Top-plate witness mark makes accurate sharpening easier LubriLinkâ„¢ tie straps help keep oil where it's needed - on the chain Vibe-Banâ„¢ chassis design reduces vibration 25% or more at the chainsaw's handles LubriWellâ„¢ oil holes help carry oil around the full length of the guide bar's groove Pitch .375" Gauge .043" (1.1mm) Sequence Standard Cutter Type Low Profile Recommended Saw Sizes 2.3-3.8 cubic inches (38-62cc) Kickback Reduction Features Bumper Link ANSI Approved Low Kickback ChainYes 100' Reel Contains 1640 Drive Links ATTENTION: This saw chain is low kickback chain. It met the reduced kickback requirements of ANSI B175.1 when tested on a representative sample of chain saws. Its safety features significantly reduce the hazard of kickback while maintaining high cutting performance. ALL CUTTING CHAINS CAN KICK BACK, which may result in severe personal injury to the chain saw operator or bystanders. Operate your chain saw safely. Read all warnings in your chain saw operator's manual.Â
- Short Description:
- 90S100U - OREGON CHAIN SAW - 100' REEL