95VPX100U - OREGON CHAINSAW CHAIN - 100' REEL *VOLUME DISCOUNTS AS LOW AS $315.00*
OREGON
® 95VPX100U chain is part of a Micro-Lite™ narrow-kerf cutting system that requires less power from the saw to cut than standard cutting systems. *VOLUME DISCOUNTS*
- ORE ROLL .325 P .050 GA 100 FT
- Micro-Chisel® cutters feature small-radius working corners for excellent performance and easy sharpening.
- Always install 95VPX100U chain on a Micro-Lite™ bar (ML or MP part numbers) to obtain all the advantages built into the Micro-Lite™ system.
- LubriLink™ tie straps help keep oil where it's needed - on the chain and LubriWell™ oil holes help carry oil around the full length of the guide bar's groove.
- Vibe-Ban™ chassis design reduces vibration 25% or more at the handles.
- 95VPX100U chain is intended for use with gasoline-powered saws from 2.2 - 2.8 cu. in. (38-62cc) with bars up to 13" - 20" (33-50cm).
- OREGON® 95VPX100U chain is a blue-label chain; it meets the low-kick-back performance requirements of ANSI B175.1 (US), and CSA Z62 (Canada) when tested with OREGON® Micro-Light™ bars.
- OREGON® 95VPX100U chain is a blue-label chain; it meets the low-kick-back performance requirements of ANSI B175.1 (US), and CSA Z62 (Canada) when tested with OREGON® Micro-Light™ bars.
- Pitch .325"
- Gauge .050" (1.3mm)
- Sequence Standard
- Cutter Type Micro-Chisel (Small Radius Semi-Chisel)
- Recommended Saw Sizes 2.2-3.5 cu in (35-57cc)
- Kickback Reduction Features Bumper Drive Link
- ANSI Approved Low Kickback Chain
 ATTENTION: This saw chain is low kickback chain. It met the reduced kickback requirements of ANSI B175.1 when tested on a representative sample of chain saws. Its safety features significantly reduce the hazard of kickback while maintaining high cutting performance. ALL CUTTING CHAINS CAN KICK BACK, which may result in severe personal injury to the chain saw operator or bystanders. Operate your chain saw safely. Read all warnings in your chain saw operator's manual. |
